Table of Contents
Advertisement
3.29
Loosen the cover nut (1) and remove the chain cover (2).
3.30
Mount the guide bar (3) and loop the saw chain (4) around the bar and sprocket (5).
(3) Guide Bar
3.31
Fit the chain tensioner nut (1) into the lower hole of the guide bar.
Then install the chain cover, fasten the nut to finger tightness.
(1) Chain Tensioner Nut
3.32
While holding the tip of the bar, adjust the chain tension by turning the tensioner
screw (1) until the tie straps on the chain just touch the bottom side of the guide bar
rail.
3.33
Tighten the chain cover nut (2) securely with the bar tip held up.
Then check the chain for smooth rotation and proper tension by moving it by hand.
If necessary, re-adjust with the chain cover loose.
(1) Tensioner Screw
(1) Chain Cover Nut
(4) Saw Chain
(2) Chain Cover
(2) Chain Cover Nut
15
(5) Sprocket
(2) Chain Cover
Hide quick links:
Advertisement
Table of Contents
