Table of Contents
Advertisement
2.4
Unscrew the fuel filler cap (1).
2.5
Carefully add the fuel/2 stroke mixture at a ratio of 40:1 (see section 4.)
DO NOT overfill, allow a 25mm gap at the top of the tank.
2.6
Once full, replace and correctly tighten the fuel filler cap.
4. STARTING PROCEDURE
WARNING
All fuels are flammable and must be handled and stored correctly.
Always ensure there is adequate ventilation when handling fuels.
WARNING
The machine is shipped without fuel/2 stroke oil mixture.
You MUST fill the engine with the correct fuel/2 stroke oil mixture before starting the
engine.
Failure to do so will result in engine damage which will not be covered by warranty.
40 Parts Unleaded Petrol
FROM COLD
3.0
Fill the fuel tank with the correct 40:1 mix of unleaded petrol and semi-synthetic 2
stroke engine oil.
3.1
DO NOT overfill, leave a 25mm gap at the top of the fuel tank.
3.2
Move the choke lever (1) to the CLOSED position.
3.3
Firmly press the primer bulb (2) 6 times until a fuel mixture is visible in the
primer bulb.
3.4
Move the ON/OFF switch (3) to the ON position.
3.5
Press the trigger lock (4) and hold the throttle trigger (5).
1 litre
2 litres
3 litres
4 litres
5 litres
(1) Fuel Filler Cap
1 Part 2 Stroke Semi-Synthetic Oil
10
25ml
50ml
75ml
100ml
125ml
Advertisement
Table of Contents
