P1PE P5200MT User Manual page 30

SPARK PLUG
WARNING
The spark plug MUST be tightened with a torque of 12-15Nm otherwise the engine
will overheat causing damage.
Only complete the following steps after the engine has been turned off and
allowed to cool.
8.8 Carefully remove the spark plug HT lead cap.
8.9 Unscrew the spark plug using the plug wrench provided (1).
8.10 Check the spark plug for visible damage and electrode erosion.
8.11 If damaged you MUST replace the spark plug.
8.12 Remove carbon deposits from the spark plug using a soft wire brush.
The spark plug gap should be 0.6 – 0.7mm.
8.13
Check the gap using a feeler gauge and adjust as necessary by carefully bending
the side electrode to achieve the correct gap.
8.14 Check the spark plug washer for damage and replace if required.
8.15 Refit the spark plug by hand to make sure it does not cross thread.
Tighten the spark plug to a torque of 12 – 15 Nm.
8.16
8.17 Reattach the spark plug HT lead cap.
0.6 – 0.7mm
30