Starting Procedure - P1PE P5200EA User Manual

3.

STARTING PROCEDURE

and all non-essential persons.
The machine is shipped without fuel/2 stroke oil mixture, therefore you MUST fill the engine with fuel/2 stroke
oil before starting the engine. Failure to do so will result in engine damage which will not be covered by
3.1. Starting procedure. – from cold i.e. machine has not been run for some time.
Put the power switch to ON position. Move the choke lever to START position. Press the primer bulb
7/8 times. Holding the machine firmly pull the recoil starter handle until machine starts. When machine
starts adjust the choke lever to the RUN position until machine runs smoothly. Allow the engine to
3.1.1. Starting procedure. – from warm i.e. machine has been run recently.
Put the switch to ON position. Make sure the choke lever is in the RUN position. Holding the machine
firmly pull the recoil starter handle until machine starts. Allow the engine to warm up for a few minutes.
Before starting make sure machine is clear of materials
warranty.
warm up for a few minutes.
Page 9