Needle Replacement Counter - Brother S-7250A Instruction Manual

4-4-3. Needle replacement counter

<Setting the needle replacement counter initial value>
1
2
3
<Needle replacement counter operation>
・ The needle replacement counter is reduced by 1 from the initial setting value each time the sewing machine sews 100
stitches, and a warning is given when the counter goes below "0".
・ Sewing will be possible even after the treadle is returned to the neutral position and the sewing machine stops. However,
after the treadle has been depressed backward and thread trimming has been carried out, sewing using the treadle will no
longer be possible.
If the treadle is depressed at this time, "Ent" will appear in the display. When the treadle is returned to the neutral position,
the display will return to the current counter display.
・ If the key is pressed during a warning, the
sewing can then be carried out using the treadle.
If the A key is pressed again for 2 seconds or more, the counter display will return to the initial value and counting from
the initial value will be possible.
4. USING THE OPERATION PANEL (ADVANCED OPERATIONS)
Press the
・ The lower thread counter value will appear in the 4-digit display.
When the
replacement counter display will appear.
・ The needle replacement counter value will appear in the 4-digit
display.
Press the A
or D key to set the initial value.
・ When the D
・ When the C
NOTE:
・ The setting range is from 0 to 9999.
・ If an initial value of "0" is set, the needle replacement counter will
not operate.
When the warning occurs, the
and the buzzer sounds for 5 seconds.
indicator and the
S-7250A
key so that the indicator illuminates.
key is pressed two or more times, the needle
key for 2 seconds or more, and then press the C
key is pressed, the setting value increases by 1.
key is pressed, the setting value decreases by 1.
indicator and the
indicator will change to illuminated and
1359D
1364D
1365D
indicator flash,
1366D
22