Sewing Continuous Backtack Stitches - Brother S-7250A Instruction Manual

3-3. Sewing continuous backtack stitches

3655M
Sewing continuous backtack stitches
1
2
3
Press the
illuminate.
Press the
If the treadle is simply depressed continuously, the number of stitches set for A, B, C and D will
be sewn in a single cycle, the thread will be trimmed automatically and then the needle bar will
stop in the needle up position.
NOTE:
・ If the treadle is returned to the neutral position while continuous backtacking is being carried
out, the sewing machine will stop at the point where the treadle returns to the neutral
position. If the treadle is depressed again, operation will resume from the point where it was
interrupted.
・ If thread trimming lock is set, the sewing machine will stop in the needle up position without
thread trimming being carried out.
If "-" is set as the number of stitches for C, the number of stitches set by AB can be sewn D
times.
For example, if D=3: ABA
If D=6: ABABAB
3. USING THE OPERATION PANEL (BASIC OPERATIONS)
key so that the
key to set the number of stitches for A, B, C and D.
For example, to select 4 stitches for A and 5 stitches for B: A-4, B-5
To select 5 stitches for C and 4 stitches for D: C-5, D-4
S-7250A
indicator and the key
1352D
2159M
16