Needle Replacement Counter - Brother S-7100A-403 Instruction Manual

4-3-3. Needle replacement counter

<Setting the needle replacement counter initial value>
1
Press the SEL key so that the COUNT indicator is illuminated.
2
When the FUNC key is pressed two times, the needle replacement
counter display will appear.
(Press two times.)
3
Press the ENTER key for 2 seconds or more, and then press the
C or D key to set the initial value.
(Press for 2 seconds or more.)
<Needle replacement counter operation>
・ The needle replacement counter is reduced by 1 from the initial setting value each time the sewing machine sews 100
stitches, and a warning is given when the counter goes below"0".
・ Sewing will be possible even after the treadle is returned to the neutral position and the sewing machine stops. However,
after the treadle has been depressed backward and thread trimming has been carried out, sewing using the treadle will no
longer be possible.
If the treadle is depressed at this time, "Ent" will appear in the display.
When the treadle is returned to the neutral position, the display will return to the current counter display.
・ If the ENTER key is pressed while the needle replacement counter is displayed, the COUNT indicator and the ABCD
indicator will change to illuminated and sewing can then be carried out using the treadle.
If the ENTER key is pressed again for 2 seconds or more, the counter display will return to the initial value and counting
from the initial value will be possible.
4. USING THE OPERATION PANEL (ADVANCED OPERATIONS)
・ The lower thread counter value will appear
in the four columns of the display.
・ The needle replacement counter value will
appear in the four columns of the display.
・ When the D
increases by 1.
When the C
decreases by 1.
NOTE:
・ The setting range is from 0 to 9999.
・ If an initial value of "0" is set, the needle
replacement counter will not operate.
When the warning occurs, the COUNT indicator and the ABCD
indicator flash, and a buzzer sounds for 5 seconds.
S-7100A
0509D
0514D
key is pressed, the setting
key is pressed, the setting
0515D
0516D
20