Setting Error Items And Destination Addresses To Which E-Mail Is To Be Sent When An Error Occurs (Mail - Recipient Settings); To Which E-Mail Is To Be Sent When An Error Occurs (Mail – Recipient Settings); Setting Error Items And The Url That Are To Be Displayed When An Error Occurs (Service & Support - Access Url) - Sharp TL-M5200 Setup Manual

Controlling the Monitor via LAN
Setting Error Items and
Destination Addresses to
which E-mail is to be Sent
when an Error Occurs
(Mail – Recipient Settings)
On this screen, you can input e-mail destina-
tions to which error notification (error items)
e-mails are sent.
Items
E-mail Set addresses to which error
Address notification e-mail is sent. You
can set up to five addresses.
Error Mail Error e-mail is sent on the error
(Backlight,
items checked in their check
Temp.) boxes.
Test Send test e-mail. This allows
you to confirm that the settings
for e-mail transmission are
properly set.
Note
• E-mail Address can be up to 64 characters.
• You can input the characters below :
a-z, A-Z, 0-9, !, #, $, %, &, *, +, -, /, =, ?, ^, {, |,
}, ~ , _, ', ., @, `
(You can input "@" only one time.)
• For details about error items, refer to the
monitor's operation manual.
-20
Description
Setting Error Items and
the URL that are to be
Displayed when an Error
Occurs
(Service & Support –
Access URL)
On this screen, you can make settings of the
URL and error items that are to be displayed
when the monitor has generated an error.
Items
Access Set the URL that is to be
URL displayed when an error
occurs. You can set up to five
addresses.
Condition The URL is displayed when an
(Backlight, error checked in their check
Temp.) boxes occurs.
Test The set URL site is test-
displayed. This allows you to
confirm that the URL site is
properly displayed.
Description