Setting Up The Monitor Network Environment - Sharp TL-M5200 Setup Manual

Setting up the Monitor Network Environment

This section describes the basic procedure for using the monitor via the network.
If the network is already constructed, the monitor's network settings may need to be changed. Please con-
sult your network administrator for assistance with these settings.
You can make network settings both on the monitor and on the computer. The following procedure is for
making settings on the computer.
Network settings on the computer
1.
Connecting the monitor to a computer
Connect a LAN cable (Category 5, cross-over type) between the computer and monitor.
You can also make the settings of steps 2 and 3 below in the menu operation of the monitor. For details, refer
to the operation manual of the monitor. (See page 37.)
2.
Setting an IP address for the computer
Adjust the IP settings of the computer to enable one-to-one communications with the monitor.
3.
Setting up a network connection for the monitor
Adjust the monitor network settings to conform to your network.
• Microsoft ® and Windows
other countries.
• All other company or product names are trademarks or registered trademarks of their respective compa-
nies.
-10
(commercially available)
® are registered trademarks of Microsoft Corporation in the United States and/or
LAN cable
Page 11
Temporarily change
the computer's IP
address.
Pages 12, 13
Use Internet Explorer
(version 5.0 or later)
to make various
monitor settings.
Page 14