Parts Supplied With The Product - Whirlpool WSI24ABBPH00 Service Manual

4.3.3 - Fitting the Dryer on the bracket
WARNING
Risk of injures due to excess of weight. Use two or more people to move
and install the Dryer.
The non-compliance with this instruction may cause damages to your
column or physical injuries.
A - Fit the Dryer through the back slots on the clamps of upper right and left
brackets. To make fitting easy, tilt the front part of the Dryer slightly.
WARNING: Check if the Dryer is correctly fitted in the upper bracket clamps, as the figure on the
side.
C - Then, screw the Dryer on the lower brackets using the two small bolts
and two washers on left and right sides (as shown in the drawing on the
side).
WARNING: This whole procedure must be followed, so your Dryer is well fixed on the bracket and
safe for use.
5 – PARTS SUPPLIED WITH THE PRODUCT:
MSEX0110i – Wall Mounted Dryer WSI24ABBPH00
B - Place the Dryer on the lower left and right brackets.
D - Make sure the Dryer is at a distance of approximately 13cm from the
wall in its whole extension.
Page 8 -21