Table of Contents
Advertisement
8.6 – Lint Filter Cleaning:
To increase and guarantee the Dryer performance, Lint Filter must be cleaned at the end of each
programming cycle. Follow the steps below to clean the lint screen:
1. Wait until the end of Dryer programming cycle,
in order to enable the cooling of internal parts.
Remove the lint filter from its casing by pulling with
the fingers inserted in the proper part holes.
2. Press the screen to unlock the cover.
3. Remove all lint caught in the filter with a soft
brush.
4. Install the lint filter by pressing the screen
against the lid until it locks in place. Check
whether the lid is well fit in the plastic grips of the
lid.
5. Once assembled the lint filter, insert it again in
the proper casing, inside the Dryer.
MSEX0110i – Wall Mounted Dryer WSI24ABBPH00
Do not wet or wash the lint filter to remove the lint,
in order to prevent rust build up.
NOTE:
Page 12 -21
Advertisement
Table of Contents
