Table of Contents
Advertisement
10.5 – On/Off Switch:
The On/Off Switch can be found inside the Instrument Support, in the right side of Dryer.
When this Switch is pushed, its contacts close and Dryer starts operating.
When the Switch is released, its contacts open and the Dryer stops operating.
KNOB
To test the Switch, check continuity between its leads with a multimeter, according to the table below:
10.6 - Heater
The Heater is located inside of the proper box behind of the Dryer.
HEATER
To test the Heater, disconnect it from the circuit and check its resistance value (in Ohms) with a Multimeter,
according to the table below:
Tension
220 V
MSEX0110i – Wall Mounted Dryer WSI24ABBPH00
TERMINALS
When the On/Off Switch is pushed
continuity between leads 1 & 2
continuity between leads 5 & 6
Ohmic value
25 to 28 Ω
SIDE A
TERMINAL 1
TERMINAL 2
SIDE B
TERMINAL 5
TERMINAL 6
TERMINALS
Page 17 -21
Advertisement
Table of Contents
