Correcting The Height Display - LOGICDATA SMARTneo Series User Manual

Press the button Table top down.
Press the button Table top down until the table top has reached the lowest table top
position (programmed table top position).
Press the button Table top down (and continue to press it).
After about 5 seconds, the table top is adjusted downward until
the absolute lowest table top position is reached.
Release the button Table top down. The electrically height-adjustable
workplace can be used as usual again.
DANGER

9.5 CORRECTING THE HEIGHT DISPLAY

With this function, you can change the height display on the display but not the table top position of the
table top. This function is available only for hand control with integrated display.
Proceed as follows:
Press the memory button.
SAVE
5 -
The display shows S –.
Press the button Table top down (arrow toward the bottom) for approx. 5 seconds.
The display starts to flash.
o 73
Now use the button Table top down (arrow toward the bottom) or table top up (arrow
toward the top) to adjust the height display.
Press the memory button.
SAVE
The height display is now set to the entered table top position.
NOTICE
USER MANUAL SMARTneo // PAGE 23
Danger of crushing
With all reset processes, the collision protection (ISP) is inactive.
Please note the increased crushing hazard hereby!
Please note that the table top position of the table top is not ch-
anged with this setting process. Only the display changes.