LOGICDATA SMARTneo Series User Manual page 37

Number Description
00 Internal error channel 1
01 Internal error channel 2
12 Defect channel 1
13 Defect channel 2
24 Overcurrent motor M1
25 Overcurrent motor M2
48 Overcurrent motor group 1
60 Collision protection
62 Overcurrent of the control
36 Plug detection at motor bushing M1
37 Plug detection at motor bushing M2
61 Motor replaced
55 Synchronisation of motor group 1 not
possible
60 Collision protection
71 Changing the anti-pinch configuration
67 Voltage too high
USER MANUAL SMARTneo // PAGE 37
Switch off the motor control unit. Con-
tact the customer service.
Disconnect the motor control unit.
Remedy the external short circuit.
or
Plug in the correct motor at the affected
bushing. Put the motor control unit into
operation again.
Remove the clamped objects from the
travel range.
Table overload -> Remove the load from
the table.
Contact the customer service.
Plug in the correct motor at the affected
bushing.
Carry out a manual reset.
Remove the load from the table.
Carry out a manual reset. If the error is
still displayed after the manual reset,
contact the customer service.
Remove the clamped objects from the
travel range. Table overload -> Remove
the load from the table.
Contact the customer service.
Refer to the DMS sensor manual in order
to activate or deactivate the anti-pinch
configuration
Disconnect the power supply cable and
contact the customer service.
Remedy