LOGICDATA SMARTneo Series User Manual page 32

DANGER
If a hand control is used with only one up and down button each, proceed as follows:
Disconnect the power supply of the SMARTneo and wait at least 5 seconds.
While the control is disconnected from the power supply, simultaneously press the but-
tons
Table top up and Table top down. Keep holding
&
this button combination.
Keep holding this button combination Table top down and Table top up while you con-
nect the control to the power supply.
&
Keep holding this button combination Table top down and Table top up until the con-
trol starts to click twice every second. Release both buttons as long as the control click
twice every second.
&
The control is reset to factory settings. The control is
now in the same state is during the first start-up.
DANGER
USER MANUAL SMARTneo // PAGE 32
Reset to factory settings
If the drives in a system are replaced, the control system must
first be reset to the factory settings and a manual reset carried
out without fail.
Reset to factory settings
If the drives in a system are replaced, the control system must
first be reset to the factory settings and a manual reset carried
out without fail.