Commissioning; Connecting Drives - LOGICDATA SMARTneo Series User Manual

7 COMMISSIONING

The table system may be assembled only by qualified persons. The workplace must be clean, dry and ESD
protected.
NOTICE
WARNING
DANGER
DANGER
Proceed as follows to commission the motor control unit SMARTneo:

7.1 CONNECTING DRIVES

Plug in the motor cables in the appropriate 8-pin motor bushings (M1, M2).
NOTICE
USER MANUAL SMARTneo // PAGE 16
Ensure ESD-oriented handling during the unpacking.
Errors that can be attributed to electrostatic discharge will void
warranty claims.
Power supply cable connection
Plug in the power supply cable only after all other electrical
connections have been established. (Motors and hand control
are connected to the control, etc.)
Commissioning only by knowledgeable staff
Commissioning of the motor control unit may be carried out
only by knowledgeable technical staff. Knowledgeable technical
staff has the necessary electrotechnical training and is familiar
with these operating instructions.
Acclimation of the product
Before assembly and commissioning of the SMARTneo ensure
that the product is acclimated for the temperature and humidity
values specified in the data sheet.
While plugging in the motor cables, be mindful of the paramete-
risation of the motor control unit.