Control System To Factory Settings Reset - LOGICDATA SMARTneo Series User Manual

When 000 flashes on the display, a manual reset is necessary. This process is
o oo
explained in Chapter 9.4.
NOTICE
NOTICE
10.10 CONTROL SYSTEM TO FACTORY SETTINGS
RESET (S0 MENU)
Simultaneously press the memory position buttons 1, 2 and the button Table top up.
1
Hold the button combination for approx. 3 seconds. Then release the buttons.
2
S 5
The display shows S and a number, e.g. S 5.
Press the button Table top up until the display shows S 0.
S O
The display shows S 0.
Press the memory button.
SAVE
The control is reset to factory settings. The control is
now in the same state is during the first start-up.
NOTICE
NOTICE
USER MANUAL SMARTneo // PAGE 31
The menu has a time-out of 5 seconds, which means that the
menu is closed automatically and without saving the settings if
no entry is made within 5 seconds.
When the menu appears, the display shows S and a number,
e.g. S 5. The number depends on the parameters of the control.
The menu has a time-out of 5 seconds, which means that the
menu is closed automatically and without saving the settings if
no entry is made within 5 seconds.
When the menu appears, the display shows S and a number,
e.g. S 5. The number depends on the parameters of the control.