Error Messages On The Display Of The Hand Control - LOGICDATA SMARTneo Series User Manual

13.2 ERROR MESSAGES ON THE DISPLAY
OF THE HAND CONTROL
Problem
H O T
The display shows
HOT.
E o o
The display shows E
and an error number.
USER MANUAL SMARTneo // PAGE 36
Cause
The motor control unit SMART-
neo is equipped with overheating
protection. This overheating
protection at activated because of
overheating.
There is an internal motor cont-
rol unit SMARTneo error.
Remedy
Wait until the motor control unit
has cooled off and the message
HOT on the display goes out. The
motor control unit SMARTneo is
then operational again.
Proceed according to the follo-
wing error list.