Table of Contents
Advertisement
Changing the Q-AMP Battery
The following steps will guide through changing the Q-AMP Battery. Any 9Volt
Alkaline battery can be used:
1. Remove the two Philips head screws from the connector end of the Q-AMP
and slide the circuit board out of the chassis.
2. Remove the old battery and reinstall anew.
3. Reinsert the Circuit Board into the first slot up from the bottom.
4. Reinstall the two Philips screws on the connector end of the Q-AMP chassis.
77
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Quiver XT and is the answer not in the manual?
Questions and answers