Table of Contents
Advertisement
Install the Test Tube
Holders (cont.)
RS-232 Interface
Connector
Thermo Scientific
To remove the rack, spread the metal tabs on
either end of the holder and lift out the
plastic Test Tube Rack.
To install the Test Tube Rack Holder onto the
shaker platform, remove the rack and rotate
the swing-bed of the holder 90° by pulling
the knobs of the locking pins on either end of
the holder outward. The pins are locked
outward by turning the knob 1/4-turn
(Figure 1-14). Attach the tray to the platform
with the screws provided.
Table 1-2. Accessory Test Tube Racks and Adjustable-Angle Rack Holders
Part No.
Description
950040
Test Tube Rack, 10-13 mm size
950060
Test Tube Rack, 16-20 mm size
600074
Test Tube Rack, 21-25 mm size
600075
Test Tube Rack, 26-30 mm size
600076
Adjustable-Angle Test Tube Holder with Rack, 10-13 mm
600077
Adjustable-Angle Test Tube Holder with Rack, 16-20 mm
600078
Adjustable-Angle Test Tube Holder with Rack, 21-25 mm
600079
Adjustable-Angle Test Tube Holder with Rack, 26-30 mm
600088
Universal Adjustable-Angle Test Tube Holder. 10-25 mm
600089
2-Tier Micro-Plate Rack
600090
3-Tier Micro-Plate Rack
194024
#10-24 Pan Head Phillips Screws for mounting test tube holders to platform
The MaxQ Orbital Shaker is equipped with an RS-232 Serial
Communication Interface for the remote transmission of data. A RJ-11
telephone style connector is located on the left side of the incubator. A
cable with RJ-11 plugs and an RJ-11 to DB-25
adapter are required. Refer to Figure 1-16 for pin
identification and Figure 1-17 for connector
locations on the shaker side panel. A cable
mountable ferrite is included for installation of
the RJ-11 cable. Loop and snap (Figure 1-15) the
ferrite over the cable to reduce electro-magnetic
emissions from the unit. Attach the ferrite device
close to the unit.
Section 1
Installation
Figure 1-14. Holder with
Rack Removed
Figure 1-15. Ferrite
Orbital Shaker
1-7
Advertisement
Table of Contents
