Sending an Image Using a Rapid Key or Speed Dial Number
Sending an image using a Speed Dial number
Use this procedure to scan a document and send the image to an E-mail, FTP,
or Desktop destination that has been stored in a Speed Dial number.
Important: To use this procedure, the setup procedures outlined on page 74
must be completed. In the case of Scan to E-mail, this includes setting a
default sender as explained in the procedure beginning on page 85 of this
manual.
♦
If you are sending the image to an e-mail destination and need to change
the subject, use the procedure on page 85.
1
Load the document(s).
•
SEND READY will appear in the
display.
RESOLUTION
•
Press
the resolution and contrast if needed.
The default resolution is FINE. Note
that STANDARD and SUPER FINE are
primarily for faxing and are not
recommended for scanning.
SPEED DIAL
2
Press
numeric keys.
•
If you enter less than 3 digits for the Speed Dial number, press
complete the entry.
•
Check the display to make sure the destination shown is correct (if not,
STOP
press
92
CONTRAST
and/or
and then enter the Speed Dial number by pressing the
and repeat Step 2).
to set
START/
to
ENTER