Leica RM2235 Instructions For Use Manual page 41

Knife holder E with a water trough for low-profile blades
11
Fig. 37
The clamping levers on the knife holder are not interchangeable. The two clamping levers
(10 and 11) must remain in the position shown at all times, as otherwise isolated malfunctions
of the knife holder can occur.
Clamping lever for the blade (10) at the right, clamping lever for the lateral displacement (11) at
the left.
Use
Leica RM2235
9
10
Floating thin paraffin sections (for example, for subsequent immunostain-
ing procedures) on the surface of the water. Flat paraffin sections can be
removed from the surface of the water using glass slides.
Fig. 38
6.
The knife holder E with a water trough is only for
low-profile blades.
The knife guard on knife holder E consists of a
red foldaway handle (9). To cover the cutting
edge, fold the knife guard handle (9) upwards as
illustrated in the figure.
The vessel is filled with water up to the blade.
After trimming, remove the section waste from
the tray and create the sections to be prepared.
The sections floating on the surface of the water
can be removed using the glass slide.
Optional Accessories
39