Replacement Of The Propellers; Binding Of Controller And Receiver - ProFlight ORBIT PFBD201 User Manual

REPLACEMENT OF THE PROPELLERS

Should one of the fitted propellers become damaged, it can be
replaced, by removing the screw from the side of the propeller
before sliding the propeller off the motor shaft. Refitting is the
reversal of removal.
It is important for the correct
blade to be placed on the
correct motor or the aircraft will
not fly correctly. Each blade is
marked with an A or B on the
underside to indicate which
motor it corresponds to.
BINDING OF CONTROLLER & RECEIVER
1. Place the aircraft on a flat surface in an open area and insert the
battery in before turning on. The lights on the underside of the
drone will flash.
2. Turn on the controller.
3. Press the left joystick up, until
the controller bleeps.
4. Press the left joystick down until
the controller bleeps again.
The front lights on the drone will
illuminate, while the rear lights flash.
The drone will then find its location
using GPS, at which point the rear
lights will illuminate constantly.
Please note this can take upto 2
minutes.
The aircraft can be flown using either
the radio control supplied or by using
the App on a smart device.
8 of 20