Replacement Of The Propellers; Binding Of Controller And Receiver - ProFlight MAVERICK AIR PFBD200 User Manual

ATTACHING THE LANDING GEAR
The landing gear is attached to the base of each of the four
motors as shown in the diagram below. They are fixed by
pushing into position.

REPLACEMENT OF THE PROPELLERS

Should one of the fitted propellers become damaged, it can be
replaced, by removing the screw from the side of the propeller
before sliding the propeller off the motor shaft. Refitting is the
reversal of removal.
It is important for the correct
blade to be placed on the
correct motor or the aircraft will
not fly correctly. Each blade is
marked with an A or B on the
top to indicate which motor it
corresponds to.
BINDING OF CONTROLLER & RECEIVER
1. Place the aircraft on a flat surface in an open area and insert the
battery in before turning on. The lights on the underside of the
drone will flash.
2. Press the left joystick back to its furthest position and hold in place.
3. Turn on the controller.
4. Move the left joystick forward to its furthest position, until the
controller bleeps.
5. Press the left joystick back again until the controller bleeps..
8 of 15