Printing Measurement Reports; Figure 1: Example Of A Measurement Report (Letter-Sized Or Dina4) - PLUSOPTIX A12C Short Manual

3 Printing measurement reports

After confirming the patient data entry or the anonymous, consecutive patient ID (see
supplementary short manual 4), a print job for label printing is sent via the infrared interface
and a measurement report is saved to the inserted SD card (plusoptiX A12) or USB stick
(plusoptiX A16) at the same time.
Attention:
All print jobs in print spooler are deleted once device is switched off or switches
off for power saving automatically. Measurement reports saved to a SD-card or
USB stick are not deleted when device is switched off or switches off for power
saving.
The measurement report is used to document the measurement values and the last camera
image. For an anonymous measurement, the measurement report is only saved to the SD
card (plusoptiX A12) or USB stick (plusoptiX A16) after entering or retrieving patient data or
confirming the consecutive patient ID number (see supplementary short manual 4).
top.png
2200 x 570 pixels
Patient
information
bottom.png
2200 x 570 pixels

Figure 1: Example of a measurement report (Letter-sized or DinA4)

Seite 4 von 10