3.2.3
Fastening the device with mounting clips or mounting brackets
Requirement
● All packaging components and protective films have been removed from the device.
● The mounting clips included in the accessory kit are to hand.
Procedure
Note
If the mounting seal is damaged, the degree of protection is not guaranteed.
Proceed as follows:
1. Working from the front,
insert the device into the
mounting cut-out. Secure
the device to prevent it from
falling out.
2. Insert a mounting clip into
the cutout provided on the
device. Make sure it is in the
correct position; see the
section "Mounting clips or
mounting brackets, position
for IP65 (Page 45)".
3. Tighten the threaded pin to
secure the mounting clip.
The maximum torque when
tightening the threaded pins
of the mounting clips is 0.5
Nm.
4. Repeat steps 2 and 3 for all
mounting clips.
5. Check the fit of the
mounting seal.
IFP, IFP PRO, IFP ETH
Operating Instructions, 11/2017, A5E31298376-AH
Installing and connecting the device
3.2 Installing the built-in unit
47