Technical Information; Certificates And Approvals - Siemens SIMATIC HMI series Operating Instructions Manual

Technical information

7.1

Certificates and approvals

Note
Approvals on the rating plate
The following overview provides information on possible approvals.
Only the approvals on the rating plate (Page 107) of the specific device apply.
CE marking
The devices meet the general and safety-related requirements of the following EU directives
and conform to the harmonized European standards (EN) for these devices published in the
official gazettes of the European Community and in the EU Declarations of Conformity:
● 2014/35/EU "Electrical equipment for use within certain voltage limits" (Low-Voltage
Directive)
● 2014/30/EU "Electromagnetic Compatibility Directive" (EMC Directive)
● 2011/65/EU "Directive of the European Parliament and of the Council of 8 June 2011 on
the restriction of the use of certain hazardous substances in electrical and electronic
equipment" (RoHS Directive)
When the device has Ex approval (see nameplate below), the following also applies:
● 2014/34/EU "Equipment and protective systems intended for use in potentially
explosive atmospheres" (Directive for Explosion Protection)
EU Declarations of Conformity
The EU Declarations of Conformity are available to the relevant authorities at the following
address:
Siemens AG
Digital Factory
Factory Automation
DF FA AS SYS
P.O. Box 1963
D-92209 Amberg, Germany
You can download information on the EC Declaration of Conformity, here under the keyword
"Declaration of Conformity":
● IFP certificates (https://support.industry.siemens.com/cs/ww/en/ps/16788/cert)
● IFP PRO certificates (https://support.industry.siemens.com/cs/ww/en/ps/21662/cert)
IFP, IFP PRO, IFP ETH
Operating Instructions, 11/2017, A5E31298376-AH
7
85