2.3
Mounting the TD 200, TD 200C, and TD400C in a Panel or on a
Surface
Mounting the TD 200, TD 200C, and TD400C in a Panel or on a Surface
Tip
If you are using a customized label insert for your TD device, you must first install the new
label insert before you mount the TD device.
Preparing the Mounting Surface for a TD 200, TD 200C, or TD400C
To prepare the surface where the TD device is to be mounted or installed, use the
dimensions for your TD device as shown below:
● For a TD 200 and TD 200C, cut a 138 mm x 68 mm hole in the mounting surface (DIN
● For a TD400C, cut a 163.5 mm x 93.5 mm hole in the mounting surface
● Refer to Table A-1 for the outside dimensions of your TD device.
68 mm
Figure 2-1
Text Display (TD) User Manual
System Manual, 08/2008, A5E00765548-03
2.3 Mounting the TD 200, TD 200C, and TD400C in a Panel or on a Surface
43700).
TD 200, TD 200C
138 mm
Dimensions for cutting a Hole in the Mounting Surface of the TD 200, TD 200C,and
TD400C
Installing your Text Display (TD) Device
TD400C
93.5 mm
163.5mm
33