2. Carefully place the device on the front panel (interfaces pointing to you), and insert the
mounting seal into the stainless steel front panel as shown. Also pay attention to numbers
④
④
Seal corner is underneath the housing frame.
⑤
The coding tap is flush on the provided cutout.
⑥
Positioning hook of the seal engages completely in cutout, flush and without overhang.
Similar to figure
3. Check the correct fit of the mounting seal:
– The coding tap is placed at the specified location.
– All positioning hooks rest flush in their cutouts. The mounting seal is installed correctly
– The edge of the mounting seal is flush with the edge of the stainless steel front all
3.3
Mounting the device
Requirement
● All packaging components and the edge protection tape, if present, have been removed.
● 1 clamping frame
● 1 torque wrench for 1.3 Nm with 2.5 mm with hex socket insert.
● Fasteners: 30 mounting clips
Siemens Drives & PLCs
IFP2200 INOX MT ETH
Compact Operating Instructions, 03/2018, A5E42185570-AA
⑥
-
.
when it lies flat on the entire stainless steel front. There must be no distortions or
overhangs as shown in the picture detail.
If necessary, adjust the seat: To do this, press the mounting seal into the cutout at the
marked points.
around.
Installing and connecting the device
3.3 Mounting the device
19