Pro Devices For Support Arm (Not Extendable, Flange Top) And For Pedestal (Extendable, Flange Bottom) - Siemens SIMATIC HMI series Operating Instructions Manual

3.3.2 PRO devices for support arm (not extendable, flange top) and for pedestal
(extendable, flange bottom)
Note
Mounting with and without a base adapter
The SIMATIC PRO devices are designed for mounting with the base adapter. If you install
the device without a base adapter, you must adjust the mechanical interface between the
support arm or pedestal and the unit accordingly, including placement of an appropriate seal
on the mechanical interface.
Requirement
● All packaging components and protective films have been removed.
● Siemens basic adapter with screws, included in product package of a PRO device for
support arm (not extendable, flange top) or for pedestal (extendable, flange bottom).
● One of the following support arms or pedestal systems:
– Support arm or pedestal with mechanical VESA interface and the corresponding
– Support arm or pedestal with mechanical interface for the Siemens base adapter
See also section "System components for PRO devices (Page 23)".
● The following cables are fed through the pedestal or the support arm to which the device
is mounted:
– Equipotential bonding cable
– Power supply cable
– Data cables, e.g. USB, DVI and DisplayPort connecting cable
IFP, IFP PRO, IFP ETH
Operating Instructions, 11/2017, A5E31298376-AH
Siemens adapter set
The type of mechanical interface differs depending on the type of support arm or
pedestal.
Recommendation: Route large connectors, such as DVI connectors, and their cables
through the pedestal or support arm first.
Installing and connecting the device
3.3 Mounting the PRO device
51