Performing The Next Measurement - PLUSOPTIX A12C Short Manual

5 Performing the next measurement

Attention:
Following an anonymous measurement, a measurement report is not saved
automatically. As soon as you return to the home page without previously saving,
the measurement report can no longer be saved and / or printed.
The measurement values, on the other hand, are saved under a consecutive
number when you take an anonymous measurement. This is shown in the header. If
you take a note of this consecutive number, you can access the measurement
values in the database at a later point in time and print the label.
After a measurement has been completed, irrespective of the "Measurement completed" or
"Measurement aborted!" measuring result, you can:
Measure the same patient again in the pre-selected measurement mode by
pressing the trigger.
Carry out another measurement of the same patient in another measurement
mode (e.g. monocular). To do this, touch the green checkmark in the navigation
bar to carry over the previously entered or selected patient data for the next
measurement.
Return to the home page by touching the red "X" button. Previously entered or
selected patient data is discarded.
Seite 7 von 7