Using The Keyfob - Pyronix Enforcer 32-WE User Manual

C. Using the Keyfob
The wireless keyfob has four buttons that may be programmed for specific functions:
no action, show status, arm area, disarm area, latch output, timed output and PA
alarm activation
Locking the Keyfob
All four buttons on the keyfob may be 'locked' to prevent a user from accidentally
pressing them.
Locking the keys on the keyfob is performed by pressing ( & II ) or (  & I )
-(the two central keys OR the two outer keys as indicated on the diagram to the right).
The RED LED will flash indicating that the fob has been locked.
To unlock, press both buttons together again and the GREEN LED will flash indicating
that the keyfob is now unlocked.
NOTE: When the keyfob is locked, all indications are also disabled
Buttons
The buttons can be customised to operate as desired (programmed in the function 'Change Codes').
Below are examples on how each button can be programmed:
 BUTTON: Programmed for 'Arm Area' When pressed, one or more areas will be armed.
 BUTTON: Programmed for 'Disarm Area'. When pressed, one or more areas will be disarmed.
I BUTTON: Programmed for 'User Output'. For example when pressed, a gate can be opened. When pressed again, a gate can be closed.
II BUTTON: Programmed for 'Status LED'. For example when pressed, the system status is shown: RED = Armed, GREEN = Disarmed, AMBER = Fault.
Quick Arming
If one of the buttons is programmed as 'Arm Area', the alarm system can be armed by the keyfob. The keypad will then start to count down the exit time
(depending on what the exit mode is programmed to by the engineer). Once the alarm panel is in this 'arming' stage, it is possible to 'quick arm' the
system by pressing the same button again; this will make the system arm immediately. The disarm LED on the keypad will turn off and a beep will be
heard once the system has been armed. The RED LED on the keyfob will be illuminated for a short time.
Page: 6