Whirlpool WDC 1070SL Service Manual page 7

2.7 Connecting the drain
1) Affix the rubber water hose for discharging water to the smallest pipe with a 5cm diameter. After removing
the curved pipe, push the rubber hose inwards and upwards. If a dedicated rubber water hose is not
available, retain the curved pipe for directing water discharge into water pail or tank.
2) The curved end of the rubber water hose for discharging water must be fixed at a height between 0.85 to
1.2m.
IMPORTANT NOTICE:
1) The drain pipe should not have blocks or kinks.
2) Make sure to create a secure between the drain hose and the machine, in order to avoid falling, scalding hot
water when washing machine goes to drain and spin cycle.
3) Is not suitable for small sink drain.
4) When the extended drain, using the same pipe, the connection must be reliable.
5) The total length of the drain cannot be more than 2.5 meters