Whirlpool WDC 1070SL Service Manual page 40

6.13 CIM Motors
Dimensions
Weight (Total Including: Motor, Pulley and MCU)
Mounting Means
Pulley
Audible Noise – Maximum limit
Motor Speed Range
Intended Application
Input Power
Shaft Power – Full Load
Winding Insulation Rating
Winding Material
Motor Thermal Protection
Name Plate
Communication Interface
Load Sensing
Out-of-Balance Sensing
Part Number:
Input Power:
Rated Voltage:
H: 177mm ; W: 174mm; L:232mm
4.4 kg – 4.7kg
4 Point Mounting per drawing(s), Mounting Isolation
Grommets NOT INCLUDED
Assumed Ratio 13.1:1
Diameter: 22.83
Type: 8 microgroove RMA-IP26, ISO 9982
Insulated: No
Motor Only
45 dBa @ 500 rpm, No load
48 dBa @ 1000 rpm, No load
58 dBa @ 1600 rpm, No load
This rating is measured at 1 meter, with the motor only and
isolated from any support structures
Bidirectional 0-17000rpm
Combo 220-240V
Rated Voltage: 220VAC
Current: 0-6A , 5A Max@220V
rms rms
Frequency: 50/60Hz
500W±15% @6000-16000RPM,25°C ambient
Class F
Aluminum Conductor
2 Klixons(MeiKai 17AM155A) separately connected in 2-
phase coils
Yes, English and Chinese Text
WIDE-BUS serial interface protocol.
Optically isolated. Requires external 5volt supply from
machine control.
Load weight can be detected by the motor.
Load Size Dynamic Range: 0-16Kg
Load Size Resolution: 0.4Kg
Out-of-Balance can be detected by the motor
OBB Dynamic Range: 0-1.7Kg
OBB Resolution: 0.1Kg
Parameters
W10538125
120W Wash/650W Spin
127V 60Hz