Rear Panel - Wohler HDM-320-4K-TT User Manual

Rear Panel

Important:
By design, the supplied AC mains power cord will only plug into a
three-prong grounded outlet for your safety. If the plug does not fit
into the outlet, contact an electrician to replace the obsolete outlet.
The symbol to the left warns of electric shock hazard inside or outside
the unit. Disconnect the power cord before removing access panels.
Important:
The monitor and power adapter have been tested as a combined
apparatus to verify compliance with applicable safety and
electromagnetic compliance standards. Use of another power adapter
provided by the user may negate the compliance or not perform
properly. Wohler Technologies cannot accept any responsibility for the
outcome in such cases.
1. SDI 1 In: This input connector accepts 3G/HD/SD-SDI video signals. It is
compliant with SMPTE 424M, SMPTE 259M, SMPTE292M/ITU-R BT601. It can
be viewed using the SDI1 selection on the Input button menu.
2. SDI 2 In: This is the second 3G/HD/SD-SDI video signal input. This
connection is compliant with SMPTE 424M, SMPTE 259M, SMPTE292M/ITU-R
BT601. It can be viewed using the SDI2 selection on the Input button menu.
Figure 2-3: Rear Panel Layout
Page
11