Table of Contents
Advertisement
Fig 76-77
Rotate the top wheel by hand, at this point. None of the
bearings should come into contact with the blade, only when in
use. Adjust the lower blade guides, and set them similarly to the
upper guides, using a Hex key to release and tighten the Hex
screws, see figs 78-79.
Fig 78-79
C
To adjust the lower thrust bearing, loosen the butterfly screw
(D), see fig 80, turn the adjusting knob (E) to move the thrust
bearing approximately 2mm behind the blade, see fig 82.
Re-tighten the butterfly screw (D).
When all adjustments have been made, recheck that when
the blade is pressed back against the thrust bearing, both the
upper and lower side guides are still behind the teeth of the
saw. Replace the guide bearing guards you removed earlier, see
fig 75 and replace the cast iron table.
2mm behind the blade
When all adjustments are complete re-connect the power,
switch the saw on and allow to run for several minutes. Check
that the blade is still tracking correctly, there is no excessive
vibration, etc. Switch off. The saw is ready to be used.
25
Setting Up the Saw
Fig 81-82
D
E
Advertisement
Table of Contents
