Front Fence Rail With Scale 4 - Axminster Trade AT2552BE Original Instructions Manual

Fig 24
Checking both sides of the table are level
Step 5 Replace the table insert by lining up the two pins in
the insert with the machined holes in the recess to the centre
of the cast iron table. Push firmly down, see figs 25-26.
Fig 25-26
Insert pin
Machined hole
Table recess
Fence Assembly
Locate the front fence rail with scale (4), rear fence guide rail (5),
fence (6), fence clamp assembly (7), M8 lift & shift handle (8), M8
threaded lever (9), threaded 'T' slot insert (10), M6x20mm bolts
(11), M6x16mm bolts (12), M8 large washer (13), M6 small
washers (14), spring washers (15) and M8 nut (16).
Step 1 Place a washer (14) over each M6x20mm bolt (12), line
up the elongated holes in the front fence rail (4) with the
pre-drilled holes to the front of the cast iron table (1), introduce
the two M6x20mm bolts (12) through the fence rail and lightly
tighten using the supplied spanner (22), see figs 27-28-29-30.
11
11
14
Step 2 Place a spring washer (15) over each M6 caphead screw
(12), line up the holes in the rear fence guide rail (5) with the
threaded holes to the opposite side of the cast iron table and
secure in place with the two M6 caphead screws (12) and using
a 5mm Hex key tighten the guide rail, see figs 31-32-33-34.
15
11
Main Assembly
Fig27-28-29-30
4
14
Spanner
12
5
Continues Over....
Fig 31