Table of Contents
Advertisement
Setting Up the Saw
Fig 57-58
A
DISCONNECT THE SAW FROM
THE MAINS SUPPLY!
Checking the table is square
Loosen the two clamping knobs beneath the table, clamping
the tilt mechanism. Lower the table until its against the stop
(19). This is a bolt with a lock nut screwed into the underside of
the table, see fig 59. The head of the bolt acts as a stop when it
strikes the machine frame. Tighten the clamping knobs.
Fig 59
19
Make sure the upper blade guide is raised as high as possible.
Place a square on the table and move it up against the blade
(behind the teeth), see fig 60.
Check that the blade is perpendicular to the table. If it is not, try
resetting the table. If it is still not correct, loosen the table lock-
ing knobs, see figs 61 and adjust the table stop bolt nut until
perpendicularity is achieved, see fig 62
Levelling stop bolt
Tighten the lock nut and then re-check. When you are satisfied
that the table is set correctly, check that the pointer of the tilt
scale reads zero, if not, adjust it, see fig 63. Retighten the table
clamping knobs.
22
Fig 60
90˚ Square
Fig 61
Fig 62
Table stop bolt
Advertisement
Table of Contents
