Axminster Trade AT2552BE Original Instructions Manual page 10

Table of Contents

Main Assembly

Step 2 Remove the table insert and table alignment pin

and place safely aside, see figs 16-17. Lift the table (1), slide

the blade through the table slot, see fig 18, line up the two

threaded bolts to the underside of the table and lower

them through the holes in the tilt quadrant assembly,

see fig 19.

Make sure the table is seated correctly on the tilt quadrant

then screw on the two clamping knobs (18) to clamp the

table (1) in position, see fig 20.

Fig 16-17

Table insert

Fig 18

Fig 19

Threaded bolt

Alignment pin

Tilt quadrant holes

Step 3 Place a 90˚ square up against the blade, loosen the tilt

quadrant clamping handles (18) and adjust the table levelling

stop bolt (19) beneath the table until the table is perpendicular

to the blade. Nip tighten the nut on the stop to lock the setting,

see figs 21-22. Retighten the clamping knobs (18).

90˚ Square

Step 4 Locate the table alignment pin you removed earlier,

place a straight edge or 90˚ square across the table's slot and

introduce the tapered alignment pin into the tapered hole to

the front of the table, this will align both sides of the table, see

figs 23-24.

90˚ Square

Fig 20

Fig 21-22

Fig 23

Alignment pin

Table of Contents