Axminster Trade AT2552BE Original Instructions Manual page 23

Fig 63
Setting the Fence
To make sure the guide fence is at 90˚ to the table, line up the
guide fence with the edge of the table's 'T' slot, see fig 64. If you
find that the fence is out of alignment follow the steps below:
1 Clamp down the fence by pushing the locking lever down,
see fig 65.
2 Loosen the 4 Hex bolts that secures the fence and
adjust until the fence is in alignment with the 'T' slot in the
table, then re-tighten the bolts, see fig 66.
3 Replace the fence assembly to its original position.
Fig 64
Fence
Fig 65-66
Pointer
Scale
Adjusting screw
'T' slot
Hex bolts
Setting the Blade Guides (above table)
DISCONNECT THE SAW FROM
THE MAINS SUPPLY!
Lower the upper blade guide to approximately 1 1/2"(38mm)
above the table. Clamp in place. Loosen the butterfly screw (A),
holding the guide assembly in place and adjust the fore and aft
position by turning the adjustment knob (B) so that the
leading edges of the side guide bearings are approximately 2
mm behind the gullets of the saw blade. Re-tighten the
butterfly screw, see fig 67-68. Loosen the butterfly screw (C)
that clamps the rear thrust bearing in position and turning the
adjustment knob (D) until the thrust bearing is approximately
2mm behind the blade, re-tighten the butterfly screw, see fig
69-70-71.
23
Setting Up the Saw
Fig 67-68
A
B
C
Continues Over....
Fig 69