The Diagnostics System; Display Functions; General Facts And Operation; Calling Up Service Mode - Bomag BW 219 DH-4 Service Training

6.1
Service Training WZ-4 from Version DH

4 The diagnostics system

The machine is equipped with a diagnostics system consisting of display unit (LC-Display) and button-
type input unit (in the travel lever) to report machine faults, display measuring values and to set param-
eters.
4.1

Display functions

The field t in the LC-Display shows the following diagnostic readings:
Type of indication
Fault message
Warning
Note
Display, measuring
values
Parameter setting
Negative display values are identified by a "Minus sign".
If several faults are detected, the displayed fault codes will change in a 3 second cycle.
4.2

General facts and operation

The following chapter describes the operation of the LC display via travel lever buttons.
4.2.1

Calling up service mode

For this purpose the display must be switched over to service mode via input mode. This is accomplished
via the two yellow Info-buttons "INFO 1" and "INFO 2" on the back of the travel lever. Navigation in input
and service mode takes place via the green and blue buttons on the front of the travel lever.
Version/Status: V3.60#00 / 20.07.12
Author:
118
Flashing Flashing "d"
warning tri-
angle
* *
* *
* *
INFO 1 Taste INFO 1 button
(yellow)
(gelb)
INFO 2 Taste
INFO 2 button
(gelb) (yellow)
Functions of ESX Control
Schöfl/ TE/TES
Flashing "d" Comment
Of the fields
next to the
warning tri-
angle
*
Change values
Werte ändern
(green)
(grün)
Navigate
Navigieren
(blue)
(blau)
BOMAG
Installation électrique ESX
Values ranging from
0 0 0 0 ...9 9 9 9 to be
called up via input codes
Values ranging from
0 0 0 0 ...9 9 9 9 to be
called up via input codes
Navigieren
Navigate
(blue)
(blau)
Werte ändern
Change values
(green)
(grün)
Page 12 of 97
008 924 62