DCS BH1 series Installation And User Manual page 39

Burner alignment
IMPORTANT!
Centre the burner onto the orifice properly before lighting the grill to prevent fire hazard or explosion.
REMOVE DRIP PAN TO VIEW CONNECTION
To replace the grill burners after cleaning
1 With the burner held at a 45 degree angle front to back, lower
each grill burner back into place, ensuring that the burner inlet
is centred on the injector inside the valve hole in the front (Fig.
32 & 33), and that the burner slides into the collector box on
the side, as shown in Fig. 34.
2 With the burner inlet and side properly in place, locate the
tabs at the rear of the burner into the matching slots on the
support bracket. Check that the burner is level and does not
rock.
3 Refit the clamps and fixing screws to secure the burner in
place.
4 Light all the burners and check for proper flame
characteristics. If adjustments are necessary, refer to the
'Burner adjustment' page in the 'Installation' section.
5 Once you have verified that the burners function correctly,
replace the grease shields, radiant trays, and grill grates.
CARE AND MAINTENANCE
Fig. 32
KNOB VALVE CONTROL
PANEL VALVE
Fig. 33
COLLECTOR BOX
"
3⁄ 8
MIN
BURNER
VENTURI
BURNER INLET
Fig. 34
37