DCS BH1 series Installation And User Manual page 11

Locating Built-in Clearances
IMPORTANT!
Never use the grill in windy conditions. If located in a consistently windy area (oceanfront,
mountaintop, etc.) a wind break will be required. Always adhere to the specified clearances as
defined in the "INSTALLATION" section of this manual.
FLAME LIFT
Wind hitting the grill while in use (especially wind blowing into or across the hood gap) can cause
poor performance and in some cases can cause the control panel to get dangerously hot.
WIND
PRIMARY INTAKE
AIR FLOW
If wind is an issue, a windscreen should be added. The windscreen should be higher than the top of
the opening in the back of the grill, with a minimum clearance of 76mm for non-combustibles, or
310mm for combustibles, from the back of the grill.
IMPORTANT!
Gas fittings, regulator, and installer supplied shut-off valves must be easily accessible.
INSTALLATION
EXHAUST
Fig. 01a
EXHAUST VENT FLOW
WIND
Fig. 01c
WIND
DIRECTION
PREFERRED
AIR FLOW
76 mm min. for
non-combustibles
310 mm min.
for combustibles
GRILL EXHAUST
EXHAUST
Fig. 01b
WIND
381 mm min.
9