DCS BH1 series Installation And User Manual page 28

USING THE GRILL
Lighting Instructions
To light dual side burners (48BQR models only)
IMPORTANT!
The side burner cover may be hot if the grill burners are in operation.
Side burners lighting instructions
First remove the burner cover and any cooking utensils from the
burner grate. Push and hold the ignition button, turn the control
HI
knob to the "HI" position until the burner is lit or four seconds
pass. If the burner doesn't ignite, wait five minutes for any
accumulated gas to dissipate then try again. If the burner will not
light after several attempts, see section 'Troubleshooting'.
Side burners match lighting
Hold a lighted match near the burner ports, turn the control knob
Fig. 20
anticlockwise to "HI". Move your hand immediately once the
burner is lit. Rotate the control knob to the desired setting.
Cap
Note: if you are using propane gas, a slight pop or flash may occur
at the burner ports a few seconds after the burner has been turned
"OFF". This extinction pop is normal for propane gas.
Side burners
The burner should never be operated if the cap is not in place
(Fig. 21).
Fig. 21
26