DCS BH1 series Installation And User Manual page 32

IMPORTANT!
 Do not use the grill burners when the rotisserie burner is on. It will burn your meat and make it very
dry. Use only one section at a time, grill or rotisserie.
 Do not cover or obstruct the upper or lower vents on the rotisserie motor unit. The motor is air-
cooled and blocking these vents may cause the motor to overheat, shortening its lifespan.
Preparation
Recommended: dental floss or butcher string, scissors, broiler pan (bottom only), pliers, meat
probe, foil, and hot pads.
Working area
Allow enough space to accommodate food and rotisserie rod assembly in a clean environment.
Meat preparation
Tie meat with butcher string or dental floss in three areas. Purchase a roast that is equally balanced
from top to bottom in size to ensure meat will cook evenly while on the rotisserie. For poultry, tie
wings and legs to the body using dental floss or butcher string to prevent flopping around while
turning.
1 Determine the center placement for the food,
put first prong on the rod, turn "L"-shaped
screw to tighten.
3 Pick up the rod, rotate it to check for balance.
If unbalanced, adjust prongs and food. Take
pliers and tighten the "L"-shaped screws on
both prongs.
30
USING THE ROTISSERIE
2 Center tied meat/poultry on the rod, place
4 Remove grates and top rack on the grill. Place
second prong, turn "L"-shaped screw to
tighten.
bottom portion of broiler pan on ceramic rods
so meat drippings can be caught in pan.