How To Connect Probe Or Bnc - Rigol DS1000CA Series Quick Manual

How to Connect Probe or BNC

1． Connect the probe
Connect the signal to CH1 using the probe according to the method
shown in the figure above:
Set the attenuation switch on the probe to "10X". Align the slot of
the probe connector with the socket of the BNC connector and insert,
then rotate the probe clockwise.
When the probes are used for the first time, you should compensate
the probes following the method below:
(1) Set the attenuation switch on the probe to "10X" and connect
the probe to CH1 on the oscilloscope. Connect the probe head
to the probe compensation signal output terminal and connect
Quick Guide for DS1000CA
RIGOL
xi