Seagull Models SEA 285 Assembly Manual page 12

Seagull de Havilland Mosquito Twin Engine RC Warbird
1) Connect the Z-bend in the 450mm
throttle pushrod to the outer hole of the
carburetor arm.
2) Slide the throttle pushrod wire into
the tube. Position the engine between the
mounts. Use four M3x25mm machine
screws to secure the engine to the mount
as shown.
Pushrod wire
3) Reinstall the servo horn by sliding the
connector over the pushrod wire. Center
the throttle stick and trim and install the
servo horn perpendicular to the servo
center line
4) Move the throttle stick to the closed po-
sition and move the carburetor to closed.
Use a 2.5mm hex wrench to tighten the
screw that secures the throttle pushrod
wire. Make sure to use threadlock on the
screw so it does not vibrate loose.
12
Machine screw M3x25mm
Instruction Manual
INSTALLING RETRACTABLE
LANDING GEAR (OPTIONNAL).
1) Locate the items necessary to install
the retracts landing gear and retract link-
age installation (excluded)
.