Ingenico Lane/5000 User Manual page 17

Flip the terminal. There is one single port on the back for
power and communications.
Connect the cable on this port of the Lane/5000.
Connect the other end to the power supply unit.
Plug the power supply into the mains.
WARNING
The main port at the back must not be used to connect a
standard video HDMI cable.
Only connect cables validated for the Lane/5000 by
Ingenico.
Note: screws can be added by the customer to hold more firmly the
trapdoor and the connector (refer to their locations on the figure
above).
The terminal can be connected to the host by several ways, with
optional cables :
High speed USB device
Ethernet
RS232
Most of the cables used with iSC and iPP ranges are compatible with the
Lane/5000. We advise to check with your reseller their compatibility if
you plan to replace an iSC or an iPP by a Lane/5000.
Following are some examples of accessories that can be used to
connect the Lane/5000. This list is not exhaustive. Please contact your
reseller for more information.
Com Box kit installation (optional)
Reference : 296148891AD
This installation kit includes a communication cable (ref.
296141785AC) to connect the terminal to the Com Box, which
dispatches on standard communication connectors :
2 USB ports (1 Host, 1 Device)
1 RS485 serial link (not usable on Lane/5000)
1 RS232 serial link
2 Ethernet ports
1 power lead
Lane/5000
900021971 R11 000 05/0917
Copyright© 2017 Ingenico
17
All rights reserved