Sony FST-ZUX999 Operating Instructions Manual page 47

Using the sound isolation
effect
You can isolate a specific frequency band
by adjusting the other frequency bands.
This function is suitable for when you
want to focus on only vocal, only bass
guitar in the original music, etc.
1
Press ISOLATOR repeatedly until
"ISOLATOR " appears.
2
Turn OPERATION JOG clockwise or
counterclockwise to adjust the sound
isolation level.
To cancel the sound isolation effect
Press ISOLATOR repeatedly until
"ISOLATOR OFF" appears.
Notes
 If you press SOUND FLASH, FLANGER
or DELAY on the unit during "ISOLATOR"
setting is used, the effect will switch to
"ISOLATOR OFF. "
 The setting of "ISOLATOR" will
automatically change to "ISOLATOR OFF"
when the system is turned off.
Creating moving sound effect
You can enjoy the moving sound among
front and rear speakers using a variety of
X-ROUND modes.
1
Press X-ROUND ON/OFF repeatedly
until X-ROUND ON/OFF button lights
up.
The last selected X-ROUND mode
appears in the display.
2
Press X-ROUND AUTO or X-ROUND
MANUAL repeatedly to select the
desired mode.
Each time you press the button, the
display changes in auto mode or
manual mode as described in the
following tables.
When using the X-ROUND AUTO
Select To output sound
AUTO WAVE In circular motion
around the room
AUTO Back and forth
FADER between the front
speakers and rear
speakers
AUTO Back and forth
BALANCE between the left
speakers and right
speakers

Continued

GB