17. Troubleshooting Based on Alarm Codes
E41: Door Opened at Cycle Start
E41
Door open.
E42: Door Open Sensing
E42
Door Lock or Wiring or Sensing Circuit on Main Board failure.
Checks to perform:
Check if the Dryer door is open?
Check for any foreign object blockage on Door
Check for any obstacle in the door opening and
Check if the Door Switch wiring terminals connected
properly?
Check the continuity between terminals of Door
Switch (in closed condition). Is the continuity there?
Replace the Electronic Control Board and repeat the
diagnostic cycle to check for any further alarms.
Error
N
O
Switch?
N
O
closing?
N
O
Y
E
S
Y
E
S
WARNING
Check that all the connectors are correctly
inserted.
Close the Door and repeat the diagnostic cycle
YES
to check for any further alarms.
Clean and repeat the diagnostic cycle to check
YES
for any further alarms.
Remove the obstacle and repeat the diagnostic
YES
cycle to check for any further alarms.
Make the connections proper and repeat the
NO
diagnostic cycle to check for any further alarms.
Change the Door Switch and repeat the
NO
diagnostic cycle to check for any further alarms.
44
E41
E42